COATINGS FOR HOSPITALS - Ivas

COATINGS FOR HOSPITALS

| BROCHURE

hai cercato: COATINGS FOR HOSPITALS indietro

Self-Levelling Antistatic Epoxy Procedure

Medium thickness, modified epoxy resin based, continuous coating for antistatic floors. Pigmented, waterproof, solvent free, containing conductive fillers for electrical conductivity. The synergy of the antistatic properties and the outstanding mechanical and chemical characteristics makes this procedure especially suitable for areas such as electronic industries, hospitals and wherever machinery that requires low conductivity flooring is used.

Intended for

Interior

hospitals and operating theatres
chemical and pharmaceutical industries
precision engineering industries
electronic engineering

TECHNICAL DATA

Suitability of the substrate (concrete)
Residual moisture content: < 5%
Compressive strength: > 22 MPa
Surface resistance to tearing: > 1.5 MPa
Total thickness of coating: approx. 2 mm

| system sheet

Composition of the System

1 Stabiliser/Primer Epoxy Fondo
2 Intermediate layer
(if required) Epoxy Fondo mortar
3 Conductive filler Mesh in copper strips
4 Antistatic primer Epoxy Fondo AS
5 Wear layer Epoplast AS

Products of the System

High Thickness Self-Levelling Epoxy Procedure

High thickness, modified epoxy resin based, continuous coating for floors. Pigmented, waterproof, solvent free, with high mechanical and chemical performance. Can be applied to substrates of different physical format, intended for heavy traffic using heavy wheeled vehicles.

Intended for

Interior

food industries
chemical and pharmaceutical industries
mechanical engineering and warehouses
electronic engineering
garages and covered car parks

TECHNICAL DATA

Suitability of the substrate (concrete)
Residual moisture content: < 5%
Compressive strength: > 22 MPa
Surface resistance to tearing: > 1.5 MPa
Total thickness of coating: approx. 3 mm

| system sheet

Composition of the System

1 Stabiliser / Primer Epoxy Fondo
2 Intermediate layer Epoxy Fondo mortar
3 Wear layer Epoplast mortar
4 Protective finish
(if required) polyurethane enamel in water dispersion: Metroresin Matt K or Metroresin Gloss K or solvent based Paviglass
(matt or glossy)